Hold / Strata Aggregates / CR-01
Governed dependency view for active aggregates production.
Active / monitoredApproved workplace-language guidance helps drivers, contractors and site teams understand key instructions at the point of scan - especially around vehicle movement, fuel handling, plant activity, stockyard operations, weighbridge activity, environmental controls and emergency response.
Safety note: Safety-critical translations should be controlled and approved before use.
Crusher line active for scheduled aggregates production. Confirm operational state before feeding material or entering the working zone. Related plant reference CR-02 is operationally known as "Zip" in older records.
Only authorised operators and supervisors should start, stop, clear or override crusher activity. Mobile plant competency is required, with the next competency review recorded for September 2026.
Keep clear of moving parts, feed zones, discharge areas and exclusion barriers. Do not enter the crusher area unless isolation or supervisor clearance is confirmed.
Blockages, jams, unusual vibration or unplanned stoppages require controlled escalation. Maintenance work must follow lockout and isolation procedure. The recorded service interval is 260 operating hours.
Crusher downtime may affect stockpile levels, dispatch availability, customer orders and weighbridge flow.
View the Aggregates operational map showing traffic flow, movement routes and related operational areas.
Dust, noise, vibration, runoff and material spillage should remain visible during active crushing operations. Stage V emissions, waste-oil collection, hydraulic-fluid controls and quarry spill-response procedure apply.
Fuel reference retained from the prototype record: ultra-low sulphur diesel, 620 litre tank capacity, average consumption around 38 litres per hour, SAE 15W-40 engine oil, ISO VG 46 hydraulic oil and AdBlue requirement.
Confirm material type before feeding. Mixed, contaminated, oversized or wet material may affect crusher performance and product quality.
Crusher sensors, telemetry and production data should support visibility of operating state, throughput and abnormal conditions.
Emergency stops, entrapment risk, fire, spill or uncontrolled movement must be escalated immediately.
Hold keeps crusher checks, stoppages, overrides, maintenance escalation and environmental concerns visible as part of the operational record.
Hold helps teams understand what depends on the crusher, what happens if it stops, and who needs to act before a small issue becomes a wider operational failure.
Operator authorisation check opened. Confirm the named operator before start, stop, clear or override activity continues.
Supervisor request logged against the active crusher record. Hold the action until clearance is confirmed.
Safety concern recorded. Keep personnel outside the exclusion area until the concern is reviewed.
Isolation guidance opened. Confirm lockout, energy isolation and supervisor clearance before entry or maintenance work.
Blockage report logged. Stop feed and use the controlled escalation route before any clearing activity.
Maintenance request raised for the crusher line. Production and stockyard dependencies remain visible while review is pending.
Isolation requirement confirmed. Do not enter or work on the crusher until lockout and clearance are complete.
Production delay logged. Stockpile, dispatch, customer order and weighbridge impacts should be reviewed.
Stockyard impact view selected. Check stockpile levels and dispatch availability before confirming load commitments.
Dust issue recorded. Confirm suppression, wind exposure and nearby working zones during active crushing.
Noise or vibration concern logged. Review abnormal conditions before production continues at normal rate.
Environmental response route opened. Check dust, noise, vibration, runoff and material spillage controls.
Material concern logged. Confirm type, size, condition and contamination risk before feeding continues.
Feed pause selected pending review. Keep the line stable until material and operator clearance are confirmed.
Sensor issue recorded. Compare machine state, telemetry and local observation before relying on production data.
Telemetry status check opened. Confirm operating state, throughput and abnormal-condition signals are current.
Emergency stop guidance opened. Use the site emergency route immediately for entrapment, fire, spill or uncontrolled movement.
Site supervisor request raised. Maintain exclusion controls until supervisor instruction is received.
Other crusher issue recorded. Add context so human judgement remains visible in the operational record.
Language support placeholder. Approved translated guidance would appear here in a live Hold deployment.